固浪瓷砖粘结剂 

      适用于玻化砖及其它墙地面砖贴砖时的背面前处理，能有效提高瓷砖与粘结材料之间的粘结强度，解决贴砖会常见的空鼓、脱落问题，对低吸水率、质地致密、表面光滑的石材也有同样效果 。抛光砖、通体砖、釉面砖、 玻化砖、防滑砖、古建砖、马赛克、大理石、花岗岩、石灰岩、板岩等高密度砖石背面的涂刷。

Applicable to the back pretreatment of vitrified bricks and other wall and floor tiles, which can effectively improve the bond strength between the tiles and the bonding materials, solve the common hollowing and falling off problems of the tiles, and have low water absorption rate. Stones with a dense texture and a smooth surface have the same effect. Brushing the back of high-density masonry such as polished tiles, whole bricks, glazed tiles, vitrified tiles, non-slip tiles, ancient bricks, mosaics, marble, granite, limestone, slate.
 

产品特点：

1：增强基材粘结力     2：施工简便、绿色环保产品

3：降低空鼓率           4：防水、防霉防老化、耐高低温

Features:

1: Enhance the adhesion of the substrate   2: Simple construction, green products

3: Reduce the empty drum rate                 4: Waterproof, mildewproof, anti-aging, high and low temperature resistant

施工工艺：

1、清理瓷砖背面浮灰、保持干净，无灰尘、油污、无疏松物等。
2、将本产品直接用滚筒均匀涂刷在瓷砖的背面即可。
3、涂刷后的瓷砖放置一旁，待胶液变成透明状后（防止粘贴时浆料被挤出），再使用
      瓷砖胶或粘贴砂浆铺贴瓷砖，能够有效提高瓷砖的粘贴能力，降低其空鼓率。

Construction process:

1. Clean the back of the tile and keep it clean, free of dust, oil, and loose matter.
2. Apply the product directly to the back of the tile with a roller.
3. Place the tile after painting to make the glue liquid become transparent (to prevent the slurry from being squeezed when pasting), and then use Tile glue or paste mortar tile can effectively improve the paste ability of the tile and reduce its empty drum rate.

注意事项：

1.施工温度应在5C-35C；

2.涂刷后的瓷砖应在终凝前粘贴完；

3.本产品无需加水，开桶搅拌均匀后直接使用，避免雨天作业

4.为确保瓷砖与基材之间同步热胀冷缩，要求留缝粘贴。粘贴外墙瓷砖的砖缝不得小于1.5MM

5.因施工操作失误或没有按照产品说明规范施工等引起质量事故本公司不负任何责任。

Precautions:

1. The construction temperature should be 5C-35C;

2. The painted tiles should be pasted before final setting;

3. This product does not need to add water, open the barrel and mix it evenly, and use it directly to avoid rainy days.

4. In order to ensure the thermal expansion and contraction between the tile and the substrate, it is required to stick the seam. The brick joint of the exterior wall tile shall not be less than 1.5MM

5. The company is not responsible for any quality accidents caused by construction operation errors or failure to follow the product specifications.

保质期：

原装密封产品在干燥阴凉的环境下存放。在正常的储存和运输条件下，产品的保质期为一年。

Shelf life:

The original sealed product is stored in a dry and cool environment. Under normal conditions of storage and transportation, the shelf life of the product is one years.

全国免费服务热线：400-843-6198

www.ch-glfs.com