固柔韧型防水涂料

 Strong wave flexible waterproof coating

产品概述Product Overview：

固浪K11防水浆料柔韧II型(厨卫专用）采用瑞士进口原材料，运用瑞士固浪最新环保防水浆料技术，是双组份聚合物改性柔性防水材料，粉料与添加剂混合，使用后得到富柔韧性的防水膜，与混凝土及砂浆有良好的粘附力，能与之形成紧密牢固的永久性结合。

Gulang K11  waterproof  paste  flexible  type II (for kitchen and bathroom) uses Swiss imported raw materials. using the latest environmental protection of Swiss solid waves  Waterproof  slurry  technology  is a  two-component polymer modified flexible waterproof  material. The powder is mixed with  additives and used. To the flexible and flexible  waterproofing  membrane,  it has good adhesion to concrete and mortar, and can form a tight and firm Long-term combination.

产品特点Product characteristics：

1. 柔韧型，可覆盖不大于2mm裂痕 ;
2. 适用于长期浸水环境 ;
3. 潮湿区域可直接施工 ;
4. 可使用在室外 , 具有良好的耐候性 ; 
5. 特别适用于墙角 , 管道周边及易渗水部位 ;
6. 净味配方、绿色环保 ;

Flexible, can cover not more than 2mm cracks, suitable for long-term immersion environment, wet area can be directly constructed, can be used in outdoor, with good weather resistance, especially suitable for corner, pipeline peripheral and pervious parts; Clean flavor formula, green environmental protection;

施工工艺Construction Technology：

1.清理基面，并充分湿润；

2.产品双组份配比为粉料 : 液料=1 : 0.41（质量比）；将液料倒入干净的搅拌容器

中，然后按比例一边搅拌一边缓慢加入粉料，充分搅拌3-5分钟直至成无粉团。

均匀的胶浆，建议使用机械搅拌，以取得最佳的搅拌效果；

3.用辊筒、刷子将浆料均匀涂刷于处理好的底材上，刷完一层后，待其略干固

（刚好不沾手）再刷第二层；

4.养护固化；防水层施工完成48小时后，进行闭水试验（温度较低或通风不良时，

可适当延迟进行）。

1. Clean and moisten the base surface. 2. The two-component ratio of the product is powder: liquid material = 1:0.41(mass ratio) ; pour the liquid material into a clean mixing container, then add the powder slowly while stirring according to the ratio, and stir thoroughly for 3-5 minutes until the powder is free. Uniform Mortar, suggest the use of mechanical mixing, in order to achieve the best mixing effect; 3. Use roller and brush to brush the slurry evenly on the treated substrate. After brushing one layer, wait until it is a little dry (just don't touch hands) and then brush the second layer. 4. Curing and curing; 48 hours after construction of waterproof layer, conduct water-tight test (when the temperature is low or poor ventilation, can be appropriately delayed) .

参考用量Reference dosage：

防水涂膜厚度在1.5mm，用量约为1.5-2.0kg/m2（实际用量视基面的实际情况以及所需求的防水层厚度而定）

The thickness of waterproof film is 1.5 mm, and the dosage is about 1.5-2.0 kg/m2(the actual dosage depends on the actual condition of the base surface and the required waterproof layer thickness)

注意事项Points to note：

1、施工温度应在5-35℃之间，避免雨天作业；

2、基层表面应清理干净，平整、坚实、无浮灰、无0.3MM以上裂缝。寒冷地区或低温

      条件下请注意产品防冻储存。添加剂储存温度不低于0℃

3、本产品含有水泥，可能会引起皮肤过敏，操作时最好戴上手套。

4、本产品无需加水，开桶搅拌均匀后直接使用。

5、因施工操作失误或没有按照产品说明规范施工等引起质量问题本公司不负任何责任。

1. The construction temperature should be between 5-35 ° C to avoid working in rainy days 2. The surface of the base should be cleaned clean, flat, solid, no floating ash, no cracks over 0.3 mm. In cold area or low temperature, please pay attention to antifreeze storage. Additive storage temperature not less than 0 ° C 3, this product contains cement, may cause skin allergies, it is best to wear gloves when operating. 4, this product does not need to add water, open the barrel to stir evenly after direct use. 5. The company shall not be responsible for any quality problems caused by construction operation mistakes or failure to follow the specifications of the product specifications.

保质期Expiration date：

原装密封产品在干燥阴凉的环境下存放。在正常的储存和运输条件下，产品的保质期为一年。

The original sealed product is stored in a dry and cool environment. Under normal conditions of storage and transportation, the shelf life of the product is one years.

全国免费服务热线：400-843-6198      www.ch-glfs.com